Research Interests: Analog CMOS IC Design, Interface and Control Electronics for MEMS Inertial SensorsJob Interests: Academic, industry R&D
was born in Ankara, Turkey, in 1986. He received the B.S. and M.S. degrees (with high honors) in electrical and electronics engineering from Middle East Technical University (METU), Ankara, Turkey, in 2008 and 2011, respectively. He is currently working toward the Ph.D. degree in Electrical Engineering and Computer Sciences at UC Berkeley under the supervision of Professor Bernhard E. Boser.
His research interests include analog CMOS IC design, interface and control electronics for MEMS inertial sensors. He was a Research Assistant at the Micro-Electro-Mechanical Systems Research and Applications Center, METU, Turkey between July 2008 and June 2012.
FM Gyroscope [BPN608]
MEMS gyroscopes for consumer devices, such as smartphones and tablets, suffer from high power
consumption and drift which precludes their use in inertial navigation applications. Conventional MEMS
gyroscopes detect Coriolis force through measurement of very small displacements on a sense axis, which
requires low-noise, and consequently high-power, electronics. The sensitivity of the gyroscope is
improved through mode-matching, but this introduces many other problems, such as low bandwidth and
unreliable scale factor. Additionally, the conventional Coriolis force detection method is very
sensitive to asymmetries in the mechanical transducer because the rate signal is derived from only the
sense axis. Parasitic coupling between the drive and sense axis introduces unwanted bias errors which
could be rejected by a perfectly symmetric readout scheme. This project develops frequency modulated
(FM) gyroscopes that overcome the above limitations. FM gyroscopes also promise to improve the power
dissipation and drift of MEMS gyroscopes. We present results from a prototype FM gyroscope with
integrated CMOS readout electronics demonstrating the principle.