Research Interests: Analog CMOS IC Design, Interface and Control Electronics for MEMS Inertial SensorsJob Interests: Academic, industry R&D
was born in Ankara, Turkey, in 1986. He received the B.S. and M.S. degrees (with high honors) in electrical and electronics engineering from Middle East Technical University (METU), Ankara, Turkey, in 2008 and 2011, respectively. He is currently working toward the Ph.D. degree in Electrical Engineering and Computer Sciences at UC Berkeley under the supervision of Professor Bernhard E. Boser.
His research interests include analog CMOS IC design, interface and control electronics for MEMS inertial sensors. He was a Research Assistant at the Micro-Electro-Mechanical Systems Research and Applications Center, METU, Turkey between July 2008 and June 2012.
FM Gyroscope [BPN608]
MEMS gyroscopes for consumer devices, such as smartphones and tablets, suffer from high
power consumption and drift which precludes their use in inertial navigation applications.
Conventional MEMS gyroscopes detect Coriolis force through measurement of very small displacements
on a sense axis, which requires low-noise, and consequently high-power, electronics. The sensitivity
of the gyroscope is improved through mode-matching, but this introduces many other problems, such as
low bandwidth and unreliable scale factor. Additionally, the conventional Coriolis force detection
method is very sensitive to asymmetries in the mechanical transducer because the rate signal is
derived from only the sense axis. Parasitic coupling between the drive and sense axis introduces
unwanted bias errors which could be rejected by a perfectly symmetric readout scheme. This project
develops frequency modulated (FM) gyroscopes that overcome the above limitations. FM gyroscopes also
promise to improve the power dissipation and drift of MEMS gyroscopes. We present results from a
prototype FM gyroscope with integrated CMOS readout electronics demonstrating the principle.