BERKELEY SENSOR & ACTUATOR CENTER
UC BERKELEY UC DAVIS
User: Guest |  Site Map |  My BSAC Profile
HOME  PROJECTS  THRUSTS  PUBLICATIONS  ABOUT BSAC  DIRECTORY  ALUMNI  FOR BSAC RESEARCHERS  EVENTS CALENDAR  SECURE LOGIN
Table of all Projects
     
 

BPN400: PZT-Actuated Flexure-Mode Membranes for Nanoscale Droplet Generation

Project ID BPN400
Website
Start Date Thu 2007-Jul-26 22:51:51
Last Updated Tue 2007-Sep-04 11:59:38
Abstract We report on the current status of device fabrication of a monolithic, micro-machined device able to generate sub-micron diameter (femtoliter) fluidic droplets. Such droplet-on-demand (DoD) devices are important for a wide range of maskless lithography and rapid prototyping technologies, including direct-write patterning on non-standard, highly topographical, or extremely temperature sensitive substrates. Printable circuitry from DoD devices can be generated in non-clean room, extreme, or dynamic conditions. The basic design of these DoD devices places a pressure source at the bottom of a macroscopic fluid reservoir. Upon actuation, the pressure source squeezes the fluid through a microscopic nozzle at the opposite end of the reservoir, thereby forming the droplets. Actuation behavior of the pressure source is critical to the operation of the device as it will define the size, speed, and ejection rate of the droplets. We have chosen a MEMS-based flexure plate actuator, rather than a thermal-bubble method, as it can achieve the requisite pressures for droplets on the scale of sub-micron diameter without introducing any thermal damage to the fluid. Advances in sol-gel-derived lead zirconate titanate (PZT) thin film deposition techniques allow for wafer scale integration of PZT as the active layer of the flexure plate. LPCVD dielectrics serve as structural underlayers for the PZT and a suspended membrane will be formed by a backside through-etch of the Si handle. Fast (~10 MHz) and uniform actuation is crucial in order to produce sufficient pressures for droplet generation, which then requires the fundamental-mode acoustic resonant frequency of these flexure plates be as high as possible. Acoustic resonance is tunable through choice of flexure plate diameter, thickness, and layering composition.
Status New
Funding Source Federal
IAB Research Area Microfluidics
Researcher(s) Nathan Emley
Advisor(s) Jeff Bokor
Detailed Information
Secure Access

Private Abstract
Research Report
Poster
Summary Slide PDF | VIDEO
Active Feedback (or Request for Response)

 

  • Copyright Notification: All papers downloaded from this site are © University of California or the publisher, all rights reserved. Contact the BSAC Webmaster for permission related to copyrighted materials.
  • Links on these pages to commercial sites do not represent endorsements by UC or its affiliates.
  • Privacy Policy
  • Contact Us

   webmaster@bsac.eecs.berkeley.edu
  User logged in as: Guest
  User Idle since: August 22, 2017, 7:38 am